Delta 36-325C User Manual

24
CONSTRUCTING A PUSH STICK
When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made
from scrap material by following the pattern shown in Fig. 61.
CUT OFF HERE TO
PUSH 1/4″ WOOD
CUT OFF HERE TO
PUSH 1/2″ WOOD
1/2″ SQUARES
NOTCH TO HELP PREVENT HAND FROM SLIPPING
Fig. 61
PUSH STICK
MAKE FROM 1/2″ OR 3/4″ WOOD OR THICKNESS LESS THAN WIDTH OF MAT’L. TO BE CUT

Delta 36-325C Specifications

General

Brand	Delta
Model	36-325C
Category	Saw
Language	English