10
TILTING THE TABLE
The table (A) Fig. 20, on your scroll saw can be tilted up
to 45 degrees to the left for bevel cutting operations.
1. Turn the table insert 90 degrees to the right. NOTE:
ROTATE THE TABLE INSERT TO ALLOW YOU TO
TILT THE TABLE WITHOUT BENDING OR BREAKING
THE BLADE.
2. Loosen table lock handle (A) Fig. 20. Tilt table (B)
Fig. 20, to the desired angle and tighten lock handle (A).
NOTE: Table lock handle (A) Fig. 20, is spring-loaded
and can be repositioned by pulling outward on handle (A)
and repositioning hub of handle on the nut located un-
derneath the hub.
3. When bevel cutting, as shown in Fig. 21, the
holddown (C) can be adjusted to lay flat on the stock. If
the workpiece is too thick causing the stock to contact
the holddown arm (D), the complete holddown assembly
can be removed, since thick stock is heavy enough to
resist lifting off the table during the blade’s up stroke.
B
Fig. 20
Fig. 21
D
C
LEVELING THE TABLE
1. Using a square (A) Fig. 22, place one end of the
square on the table and the other end against the blade,
as shown. Check to see if the table is 90 degrees to the
blade.
2. If the table is not at 90 degrees to the blade, loosen
table lock handle (B) Fig. 23, and adjust the table until it
is 90 degrees to the blade. Then loosen screw (C) and
adjust pointer (D) until it points to the 0 degree mark on
the scale (E).
Fig. 22
A
Fig. 23
E
B
D
C
A
To Next Page
Loading...
Need help?
General
