Delta 40-530 User Manual

8
WRENCH AND BLADE
STORAGE
A convenient wrench and blade holder (A) Fig. 13, is
supplied on the left side of the rear casting, which allows
you to store the quickset blade changing wrench (B) and
extra scroll saw blades when not in use.
A
B
Fig. 13
CHANGING BLADES
WARNING: THE USE OF ACCESSORIES OR AT-
TACHMENTS NOT RECOMMENDED BY DELTA MAY
RESULT IN RISK OF INJURY.
1. WARNING: TO AVOID INJURY FROM ACCIDEN-
TAL STARTING, ALWAYS TURN SWITCH “OFF” AND RE-
MOVE POWER CORD PLUG FROM ELECTRICAL OUT-
LET BEFORE REMOVING OR REPLACING BLADE.
2. Remove table insert.
3. Position blade tension lever (A) Fig. 19, in the vertical
position to release blade tension.
4. Insert long end (A) Fig. 14, of quickset blade
changing wrench into hole (B) in upper blade holder. This
will automatically align wrench (C) with blade holder
screw (D).
5. Fig. 15, illustrates the quickset blade changing
wrench (E) engaged with the upper blade holder
assembly. Turn wrench counterclockwise to loosen
screw (D) and remove blade (F) from upper blade holder
as shown.
Fig. 14
A
B
D
C
E
D
F
Fig. 15

Delta 40-530 Specifications

General

Brand	Delta
Model	40-530
Category	Saw
Language	English