8
This tool is intended for use on a circuit that has an out-
let and a plug that looks like the one shown in Fig. 15. A
temporary adapter, which looks like the adapter illustrat-
ed in Fig. 16, may be used to connect this plug to a 2-
pole receptacle, as shown in Fig. 16, if a properly
grounded outlet is not available. The temporary adapter
should be used only until a properly grounded outlet can
be installed by a qualified electrician. THIS ADAPTER IS
NOT APPLICABLE IN CANADA. The green-colored
rigid ear, lug, and the like, extending from the adapter
must be connected to a permanent ground, such as a
properly grounded outlet box, as shown in Fig. 16.
WARNING: IN ALL CASES, MAKE CERTAIN THE
RECEPTACLE IN QUESTION IS PROPERLY
GROUNDED. IF YOU ARE NOT SURE, HAVE A CER-
TIFIED ELECTRICIAN CHECK THE RECEPTACLE.
Fig. 15
Fig. 16
FASTENING SCROLL SAW
TO SUPPORTING SURFACE
GROUNDED OUTLET BOX
GROUNDED OUTLET BOX
CURRENT
CARRYING
PRONGS
GROUNDING BLADE IS
LONGEST OF THE 3 BLADES
GROUNDING MEANS
ADAPTER
Fig. 17
Your scroll saw MUST be securely fastened to a stand
or workbench using the holes in the four rubber feet,
three of which are shown at (A) Fig. 17. IMPORTANT:
When mounting the saw to a stand or workbench DO
NOT over-tighten mounting bolts. Leave some cushion
in the four rubber feet (A) for absorbing noise and vibra-
tion.
An alternate method of securing the scroll saw to a sup-
port-ing surface isto C-clamp the front and side ledge of
the saw base to a workbench.
IMPORTANT: If there is any tendency for the stand or
workbench to move during operation, the stand or work-
bench must be fastened to the floor.
A
A
To Next Page
Loading...
Need help?
General
