Delta AS02LC-A User Manual

AS Series Module Manual
9- 16
_9
9.4 RTU Mode
9.4.1 CANopen Mode (AS-FCOPM)
When the function card AS-FCOPM works with an AS series PLC, it supports three kinds of RTU modes, including AS
Remote Communication, CANopen DS301 Mode and Delta Special Driver & AS Remote Mode. Use the knob
FORMAT 1 to turn among three RTU modes.
A. RTU Communication Mode Setup Knob “FORMAT 1”
FO RM AT 1
Description
0 AS Remote Communication
4 CANopen DS301
8
Delta Special Driver & AS Remote Mode
B. Node ID Setup Knob “ID1/ID2”
 ID1: 0 (recommended)
 ID2: 0 (the knob is no function; set up through ISPSoft); see the table below for the knob setting
range.
RTU mode
ID2 setting range
AS Remote Communication
1~F
(by the number of slaves)
Delta Special Driver & AS Remote Mode
1~F
(by the number of slaves)
CANopen DS301
1~F
(if the knob is at 0, the setting range is set by
HWCONFIG)
C. RTU Communication Speed Setup Knob “FORMAT 2”
Use the knob for setting. You cannot use ISPSoft (HWCONFIG) to set up the communication mode in this
format.
FO RM AT 2
1 2 3 4 5 6 7 8-F
Byte (bps)
10K 20K 50K 125K 250K 500K 1000K NA
Distance (m)
5000
2500
1000
500
250
100
25
NA

Delta AS02LC-A Specifications

General

Brand	Delta
Model	AS02LC-A
Category	Network Hardware
Language	English