To Next Page

To Previous Page

3. The table can be tilted right or left by removing the

table alignment pin (C) Fig. 25.

NOTE: If the pin (C) is difficult to remove, turn the nut (E)

clockwise to pull the pin out of the casting.

4. Loosen the table locking bolt (D) Fig. 26, tilt the

table to the desired angle, and tighten the bolt (D).

When you return the table to the level position,

replace the table alignment pin (C) Fig. 25 to

position the table surface 90 degrees to the

spindle.

5. A tilt scale (E) Fig. 27 is provided on the table

bracket casting to indicate the degree of tilt. A

witness line and zero mark (F) are also provided on

the table to align with the scale (E).

TABLE ADJUSTMENTS

1. Raise or lower the table on the column by

loosening the table clamp (A) Fig. 23, and turning

the table raising and lowering handle (B) Fig. 24.

After the table is at the desired height, tighten the

clamp (A) Fig. 23.

NOTE: Always raise (rather than lower) the table to the

final position to allow the gears to mesh and prevent

slippage.

2. The table can be rotated 360 degrees on the column

by loosening the clamp (A) Fig. 23, rotating the table to

the desired position, and tightening the clamp (A).

Fig. 23

Fig. 24

Fig. 25

Fig. 26

Fig. 27

Delta DP300 User Manual

Questions and Answers: