26
USING AUXILIARY WOOD FACING ON RIP FENCE
Fig. 71
A
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call
the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
When performing special cutting operations – and that
operation may cause the cutting implement to contact
the fence – it is necessary to add a wood facing (A) Fig.
71, to one side of the rip fence as shown. The wood
facing is attached to the fence with wood screws
through holes drilled in the fence. 3/4-inch stock is
suitable for most work, although an occasional job may
require one-inch facing.
To Next Page
Loading...
Need help?
General