Delta VFD-H User Manual

16
4
Start-up
This chapter describes the steps needed to start the AC drive and typical adjustment
and verification procedures to ensure a simple and efficient start-up. The following
start-up procedures describe the most common parameter settings and system
configurations.

Initial Operation - Motor Disconnected
 Verify that the AC power line, at the disconnect device, is within the rated power
of the AC drive.
 Disconnect and lockout all incoming power to the drive.
 Connect the AC drive to the power line.
 Reconnect the incoming power to the drive.
 Proceed as follows to select a mode of operation.
1. Operating frequency determined by the digital keypad,
Digital keypad enabled to control AC drive operation.
(Pr.00 = d0000, Pr.01 = d0000) (Factory default setting)
IM
2. Operating frequency determined by the digital keypad,
Control terminals enabled to control AC drive operation; ”Stop” key on digital
keypad is enabled.
Two wire “REV/STOP” and “FWD/STOP” remote control enabled.
(Pr.00 = d0000, Pr.01 = d0001, Pr.38 = d0000)
REV/STOP
FWD/STOP
IM
FWD
REV
DCM

Delta VFD-H Specifications

General

Brand	Delta
Model	VFD-H
Category	DC Drives
Language	English