10
Pairing a Bluetooth Device Using NFC
NFC (near-field communication) allows data exchange from devices, such as
pairing, by gently bumping them together. Check in your device’s manual to see if
this feature is supported.
To use NFC to pair with Audio Commander:
1. In order to use NFC, your device must be turned on and unlocked.
2. Enter your device’s Settings menu and check that NFC is turned On.
3. Power on Audio Commander.
4. Press and release the Bluetooth button on Audio Commander.
5. Touch and briefly hold your device to the NFC logo.
6. Follow the pairing instructions that appear on your phone. If a passcode is
required, enter ‘0000’.
Note: Use the Mode button to select Bluetooth as the source.
To unpair, gently bump your device against the NFC logo located on top of Audio
Commander.
Linking Two Audio Commanders
1. Power on each Audio Commander.
2. Connect a 1/4” (6.35 mm) audio cable from the Line Out of the first Audio
Commander to the Line In of the second Audio Commander.
3. Ensure the Line/Mic switch is set to Line.
4. Play your music on the first Audio Commander.
5. Adjust the Master volume knob on the first Audio Commander and then adjust
the Mic/Line volume on the second Audio Commander.
To Previous Page
Loading...
Need help?
General
