Denon AVR-1712 User Manual

45
Playback in ZONE2 (Separate room)
•You can operate this unit so as to enjoy audio in a room (ZONE2)
other than the MAIN ZONE (room where the unit is located).
•You can simultaneously play back the same source in both the MAIN
ZONE, ZONE2. You can also play back separate sources in the MAIN
ZONE and ZONE2.
Audio output
Zone playback by speaker output
The ZONE2 audio signals are output from this unit’s SURR.BACK/AMP
ASSIGN speaker terminals using the amplifier assignment function.
nConnecting and setting the speakers
“Amp Assign” setting
(vpage60) and audio
signals output
Connecting the speakers
ZONE2
Output signal :
Stereo (L / R)
ZONE2
w q w q
(L) (R)
We recommend using high quality pin-plug cables for audio
connections in order to prevent noise.
NOTE
It is not possible to play the digital audio signals input from the HDMI,
COAXIAL or OPTICAL connectors in ZONE2.
Playback
1
Press ZONE SELECT to switch the
zone mode to K (ZONE2).
Input source
select buttons
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press ZONE/DEVICE Z to turn on
the ZONE2 power.
The indicator on the display lights.
•Also press input source select button when
in standby mode, the power turns on.
•When
ZONE/DEVICE X is pressed, ZONE2
turns off.
•Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
•To perform an operation with the main unit, press
ZONE2 SELECT
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select J (MAIN ZONE) in
step 1 then press ZONE/DEVICE X.
Adjusting the volume
Use M df to adjust the volume.
GAdjustable rangeH
– – – –80dB – –40dB – 18dB
(When the “Volume Display” (vpage65) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage65) setting is “Absolute”)
•At time of purchase, “Volume Limit” (vpage 65) is set to
“–10dB (71)”.
Turn MASTER VOLUME after pressing ZONE2 SELECT on the main
unit to adjust the sound volume.
Turning off the sound temporarily
Press N.
The sound is reduced to the level set at “Mute Level” (vpage65)
in the menu.
•To cancel, either adjust the volume or press N again.
•The setting is canceled when the zone’s power is turned off.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD

Denon AVR-1712 Specifications

General

Brand	Denon
Model	AVR-1712
Category	Stereo Receiver
Language	English