94
Menu map
For menu operation, connect a TV to this unit and display the menu on the TV screen. For menu operations, see the following page.
By default, this unit has recommended settings defined. You can customize this unit based on your existing system and your preferences.
How to make detailed settings
Setting items Detailed items Description Page
Audio
Surround Parameter Adjusts surround sound parameters.
100
Tone Adjusts the tonal quality of the sound.
102
Dialogue Level Sets the output level to clarify the dialogue
output from the center channel.
102
Subwoofer Level Sets the subwoofer on/off and its output level.
102
Restorer Expands the low and high frequency components
of compressed audio to enable richer audio
playback.
102
Audio Delay Compensates for incorrect timing between video
and audio.
103
Volume Set the MAIN ZONE (room where the unit is
located) volume setting.
103
Audyssey Makes Audyssey MultEQ
®
XT, Audyssey
Dynamic EQ
®
and Audyssey Dynamic Volume
®
settings.
103
Graphic EQ Uses the graphic equalizer to adjust the tone of
each speaker.
104
Video
Picture Adjust Adjusts the picture quality.
106
HDMI Setup Makes settings for HDMI video/audio output.
106
Output Settings Makes screen-related settings.
107
Volume Display Sets where to display the master volume level.
108
Info Display Displays status of operation temporarily when
the sound mode is changed, or input source is
switched. You can set whether or not to show
each of these status displays.
108
Audio Display Sets how long each menu is displayed when the
input source is “NETWORK”, “iPod/USB”, or
“FM”.
109
TV Format Set the video signal format to be output for the
TV you are using.
109
Setting items Detailed items Description Page
Inputs
Input Assign Changes input connector assignment.
111
Source Rename Changes the display name for this source.
112
Hide Sources Remove from the display input sources that are
not used.
112
Source Level Adjusts the playback level of the audio input.
113
Input Select Sets the audio input mode and decode mode.
113
Video Source Video of another input source is played back
combined with the playing audio.
113
Speakers
Audyssey
®
Setup The acoustic characteristics of the connected
speakers and listening room are measured and
the optimum settings are made automatically.
24,85
Manual Setup Perform when setting the speakers manually
or when changing settings made in Audyssey
®
Setup.
115
Network
Information Display network information.
119
IP Control Set the network function on/off during standby.
119
Friendly Name The Friendly Name is the name of this unit
displayed on the network. You can change the
Friendly Name according to your preferences.
119
Settings Make settings for wired LAN.
120
Maintenance Mode Use when receiving maintenance from a DENON
service engineer or custom installer.
121
To Next Page
Loading...
Need help?
General
