System Setup System Setup
ENGLISH
19
ENGLISH
¢ Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only
possible in the “Auto” mode and only valid in the STANDARD (Dolby /
DTS Surround) mode. The adjusted levels are automatically stored for
the different surround modes.
Press [TEST TONE].
•Test tones are output from the different speakers.
Press [TEST TONE].
Press
FF GG
to adjust the volume.
1
2
3
•To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 32.
Input Setup
Setting the Digital In Assignment
Press
FF GG
to select “2. In”, then press ENTER.
Press ENTER or
HH
to enter the setting and switch to
the iPod Assignment setting.
Press
DD HH
to select the input terminals, then press
FF
GG
to set.
• Digital input terminal assignment not possible for “TUNER”.
• It is not possible to make the Digital In Assignment settings for the
function assigned at iPod Assignment mode.
2
1
CD, AUX, DVD, TV, VCR, V.AUX, CD-R:
Assign the different source according to the devices connected to
the AVR-487’s input terminals.
3
This assigns the different input sources for the digital input terminals.
5
Press
FF GG
to set.
Setting the iPod Assignment
It is possible to assign the Control Dock for iPod’s (ASD-1R, sold
separately) audio and video signals to any input terminals on the AVR-
487 and play them.
1
OFF:
This is the factory default setting.
CD, AUX, CD-R:
When using a Control Dock for iPod, it is possible to connect with
the audio input terminal of the assigned function.
DVD, TV, VCR, V.AUX:
When using a Control Dock for iPod, it is possible to connect with
the audio and video input terminals of the assigned function.
Press ENTER or
HH
to enter the setting and switch to
the EXT. IN Subwoofer Level setting.
2
To Next Page
Need help?
General
