Basic Operation Basic Operation
ENGLISH
23
ENGLISH
¢ DIRECT mode
This mode is for playing with high quality sound. The audio signals are
transmitted directly, without passing through the tone circuits, etc.
Selecting the play mode (DIRECT/STEREO)
The AVR-487 is equipped with two 2-channel playback modes
exclusively for music. Select the mode to suit your tastes.
Press [DIRECT/STEREO] to select “DIRECT”.
¢ STEREO mode
Use this mode to adjust the tone and achieve the desired sound.
Press [DIRECT/STEREO] to select “STEREO”.
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
INPUT MODE
D H F G
SURROUND
PARAMETER
[STANDARD]
[DIRECT/STEREO]
ENTER
SURROUND PARAMETER D H
STATUS
F G, ENTER
INPUT MODE
Selecting the Dolby Digital and DTS Surround
mode (only with digital input)
Play a program source with the , mark.
•“ ” or “ ” lights, depending on the source.
Press SURROUND PARAMETER.
Press
DD HH
to select the item, then press
FF GG
to set.
The parameter switches as shown below each time the button is
pressed.
Press [STANDARD] to select “STANDARD (Dolby/DTS
Surround)”.
3
6
5
4
Select an input source for which digital (COAXIAL or
OPTICAL) is set ( page 19).
1
Press INPUT MODE to select “AUTO”.
2
CINEMA EQ.:
Use this if movie dialogues sound harsh to lower the treble sound.
Effective source mode
Dolby Pro Logic II / Dolby Pro Logic / Dolby Digital /
DTS Surround / DTS NEO:6 / NEURAL SURROUND
CINEMA EQ
D.COMP.
LFE
TONE DEFEAT
DEFAULT
If you do want the bass and treble to be adjusted, turn off the tone
defeat mode.
To Next Page
Loading...
Need help?
General
