55
15
TROUBLESHOOTING
If a problem should arise,first check the following.
1. Are the connections correct ?
2. Have you operated the receiver according to the Operating Instructions ?
3. Are the speakers, turntable and other components operating property ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase.
Symptom Cause Measures Page
DISPLAY not lit and sound not produced
when power switch set to on.
• Power cord not plugged in securely. • Check the insertion of the power cord plug.
6
DISPLAY lit but sound not produced.
• Speaker cords not securely connected.
• Input source selector button position is not
appropriate.
• Volume control set to minimum.
• MUTING is on.
• No digital signal is being input.
• Speaker A or B button is set to “OFF”.
• Connect securely.
• Switch to the proper position.
• Turn volume up to suitable level.
• Switch off MUTING.
• Properly select a digital signal input source.
• Set the button for the connected speaker
terminals to “ON”.
12, 13
33
34
35
28
19
Nothing is displayed on monitor.
• AVR-5800’s video output jacks and monitor’s
input jacks are not properly connected.
• Monitor TV’s input setting is wrong.
• Connections of the various component’s video
signals are not unified.
• Check that the connections are correct.
• Set the TV’s input selector to the jacks to which
video signals are connected.
• Unify to composite or S jack.
7 ~ 9
7 ~ 9
7 ~ 9
No dts sound is produced.
• DVD player’s audio output setting is not set to bit
stream.
• DVD player is not dts-compatible.
• AVR-5800’s input setting is set to analog.
• Make the DVD player’s initial settings.
• Use a dts-compatible player.
• Set to AUTO or dts.
—
—
33
Copying from DVD to VCR is not
possible.
• Mode video software contains copy prohibit
signals.
• Copying is not possible.
—
No sound is produced from subwoofer.
• Subwoofer’s power is not on.
• Subwoofer’s initial setting is set to “NO”.
• Subwoofer’s output is not connected.
• Turn on the power.
• Set the setting to “YES”.
• Connect properly.
—
19
13
No test tones are produced.
• Surround mode is set to a mode other than
Dolby Surround.
• Set to Dolby Surround.
—
No sound is produced from surround
speakers.
• Surround mode is set to “STEREO”. • Set to a mode other than “STEREO”.
—
Dolby Digital is not possible with LDs.
• Not connected to Dolby Digital jacks. • Connect the LD player’s Dolby Digital RF output to
the AVR-5800’s Dolby Digital RF input jacks.
7
This unit does not operate properly when
remote control unit is used.
• Batteries dead.
• Remote control unit too far from this unit.
• Obstacle between this unit and remote control
unit.
• Different button is being pressed.
• < and > ends of battery inserted in reverse.
• Replace with new batteries.
• Move closer.
• Remove obstacle.
• Press the proper button.
• Insert batteries properly.
31
31
31
—
31
To Next Page
Loading...
Need help?
General
