27
ENGLISH
ENGLISH
Basic Operation Basic Operation
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
2
Press and hold in the SURROUND PARAMETER
button to select the parameter you want to set.
The parameters which can be set differ for the different
surround modes are displayed. (Refer to “Surround modes
and parameters” ( page 56).)
3
Display the parameter you want to adjust, then
turn the SELECT knob to set it.
When turned counterclockwise:
To select the surround mode while adjusting the surround
parameters, tone defeat or tone control, press the
SURROUND MODE button, then operate the selector.
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small),
“medium”, “med.l” (medium-large) and “large”. “small”
recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
DIRECT.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
3
Press the SURROUND PARAMETER button, and
press the CURSOR
DD
or
HH
button to select the
various parameters.
5
Press the ENTER button to finish the surround
parameter mode.
4
Press the CURSOR
FF
or
GG
button to adjust the
parameter settings.
DSP surround simulation
2 To operate the surround mode and the surround
parameters from the remote control unit
1
Select the surround mode for the input channel.
(Remote control unit)
2
Press the SURROUND PARAMETER button to
enter the surround parameter setting mode.
The surround mode switches in the following order each
time the DSP SIMULATION button is pressed:
The surround parameter switches in the following order
each time the SURROUND PARAMETER button is pressed for
the different surround modes.
2 Operating the surround mode and the surround
parameters from the main unit‘s panel
1
Turn the SELECT knob to select the surround
mode.
When turned clockwise:
To Next Page
Loading...
Need help?
General
