o
Bluetooth cannot be played back
Symptom Cause / Solution Page
Bluetooth devices cannot
be connected to this unit.
0
The Bluetooth function in the Bluetooth device has not been enabled. See the Owner’s Manual of the
Bluetooth device to enable the Bluetooth function.
－
0
Bring the Bluetooth device near to this unit. －
0
The Bluetooth device cannot connect with this unit if it is not compatible with the A2DP profile. －
0
Turn the power of the Bluetooth device off and on again, and then try again. －
0
Set “Network Control” to “On” and connect again.
79
NFC connection fails
0
Check the NFC settings on each Bluetooth device. －
0
Cancel the Lock function on each Bluetooth device. －
0
Check the NFC position on each Bluetooth device, and then move the NFC close to Q on this unit.
50
0
Set “Network Control” to “On” and connect again. 79
The sound is cut off.
0
Bring the Bluetooth device near to this unit. －
0
Remove obstructions between the Bluetooth device and this unit. －
0
To prevent electromagnetic interference, locate this unit away from microwave ovens, wireless LAN
devices and other Bluetooth devices.
－
0
Reconnect the Bluetooth device. －
o
File names on the iPod/USB memory device are not displayed properly
Symptom Cause / Solution Page
The file names are not
displayed properly (“…”,
etc.).
0
Characters that cannot be displayed are used. This is not a malfunction. On this unit, characters that
cannot be displayed are replaced with a “.” (period).
－
Contents Connections Playback
Settings
Tips Appendix
96
Front/Top
panel
Rear panel
Remote control unit
Index
To Next Page
Loading...
Need help?
General
