14
ENGLISH
8
CLOCK ADJUSTMENT
[Example] To set the current time to “7:30 PM
Wednesday” (12-hour display mode).
1
Press the button to turn the
power on.
CLEAR
123
546
789
+1 0
10
TUNING
TONE/SDB
REPEAT
CALL
PROG/
DIRECT
RANDOM
ENTERDISPLAY MENU
SLEEPFOLDERTITLETIME
POWEROPEN / CLOSE
STOP
/BAND
PLAY/PAUSE
VOLUME
FUNCTIONMUTE
PRESET
+
-
5
2
4, 6, 8, 10
1
3, 5, 7, 9
3
Press the +/− buttons to
select “ClockAdjust”.
7
Press the +/− buttons to
adjust the hour “7 PM”.
9
Press the +/− buttons to
adjust the minutes “30”.
2 Be sure to set the current time beforehand.
5
Press the +/− buttons to
select “Wed”.
10
Press the ENTER button at
the sound of the chime
indicating the time is
currently 7:30 PM.
• The current time is displayed, the
“MENU” indicator turns off and
the setting is completed.
The clock may go off by up to about 1 minute
per month. If it is off, reset the time.
1
Press the MENU button.
TONE/SDB
ENTERDISPLAY MENU
SLEEPFOLDERTITLETIME
STOP
/BAND
PLAY/PAUSE
VOLUME
FUNCTIONMUTE
PRESET
+
-
1
3, 5, 7
2, 4, 6
2
Press the +/− buttons to
select “AutoOffMode”.
Auto off mode setting
3
Press the ENTER button.
4
Press the +/− buttons to
make “On” or “Off”
flash.
The selected setting (“On”
or “Off”) switches each
time the +/− buttons is
pressed.
The setting that is flashing is the one that
is selected.
5
Press the ENTER button.
• The “MENU” indicator turns off
and the setting is completed.
When “Off” is selected
Press the ENTER button.
Proceed to step 6.
6
Press the +/− buttons to
setting the time.
Each time you press this
buttons, the display
changes as follows:
7
Press the ENTER button.
• The “MENU” indicator turns off
and the power is set to the
standby mode after the set time.
2 Be sure to set the current time beforehand.