Denon DCD-1700NE - Page 23

Switching the display’s brightness
The brightness of the display can be adjusted to one of four levels.
Switching the display off reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
1
Press DIMMER.
0
The brightness of the display switches each time the button is
pressed.
0
The display brightness is set to most brightly by default.
0
The DIMMER button also controls the Denon's Integrated Amplifier PMA-1700NE,
so the PMA-1700NE can be operated simultaneously with this unit. When the two
units have different settings, press and hold in the button for lease 2 seconds to
reset them both to the default setting, then make the desired setting.
Switching the pure direct mode
When the pure direct mode is used, the display turns off and digital output
stops.
This reduces the source of noise that can adversely affect sound quality,
enabling high quality playback.
1
Press PURE DIRECT.
The display turned off, and pure direct playback begins.
0
To turn off this mode, press PURE DIRECT again.
0
You can also switch the pure direct mode by pressing PURE DIRECT on the main
unit.
0
In the pure direct mode, DIMMER is not available for operation.
0
The display is only turned off during playback.
Contents Connections Playback Settings Tips Appendix
23
Front panel Display Rear panel Remote Index