Denon DHT-390XP User Manual


Getting Started Playback Information Troubleshooting
ENGLISH
Specications
Distance
Set distance from listening position to speakers.
Before making the settings, measure the distance from the
listening position to the different speakers.
[Variable range]
0.0 ~ 9.0 M
: Display when “M” is set.
0 ~ 30 FT
: Display when “FT” is set.
Crossover Frequency
Select crossover frequency from which subwoofer handles low
range signal.
• For speakers set to “S”, sound below the crossover frequency is
cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• Always set the crossover frequency to “120HZ”. When using small
speakers, however, we recommend setting the crossover frequency
to a higher frequency.
Unit
Select unit for distance.
Distance measurement
Select the speaker you want to set, then set the distance.
Set the value closest to the measured distance.
[Selectable items]
NORM
: Play low range and LFE signal of channels set to “S”.
SW+
: Play low range and LFE signal of all channels.
Subwoofer Mode Setup
Select low range signal to be reproduced by subwoofer.
•Thiscan beset when“SpeakerSetup” –“Speaker Conguration”
–“Subwoofer”issetto“Y”.
• Play music or a movie source and select the mode offering the
strongest bass.
• Select “SW+” if you want the bass signals to always be produced
from the subwoofer.
[Display]
[Display]
[Display]
• When “Front Speaker” is set to “S”, “Subwoofer” is automatically
setto“Y”.
• If “Subwoofer” is set to “N”, “Front Speaker” is automatically set to
“L”.
• When “Front Speaker” is set to “S”, “Center Speaker” and “Surround
Speaker” can not be set to “L”.
Subwoofer
Select subwoofer use.
[Selectable items]
Y
: Select this when a subwoofer is connected.
N
: Select this when no subwoofer is connected.
[Selectable items]
M
: Displays the distance setting in meters.
FT
: Displays the distance setting in feet.
[Variable range]
40HZ
~
120HZ
~
130HZ
Only the portion of the bass sound of the various speakers output
from the subwoofer that has a frequency below the frequency set
here is output.
Set this according to the low frequency reproduction capabilities of
the speakers you are using.
Connections Setup
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 15).
L
: Select this when using large speakers with ample low frequency
reproduction capabilities.
S
: Select this when using small speakers without ample low
frequency reproduction capabilities.
N
: Select this when no speaker is connected.

Denon DHT-390XP Specifications

General

Brand	Denon
Model	DHT-390XP
Category	Receiver
Language	English