55
ENGLI
16
LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with the power
cord disconnected.
17
INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1
Press the power button to set the
standby mode, then unplug the set’s
power cord from the wall power outlet.
2
After at least 10 seconds, press the SURROUND MODE
button on the AVR-M330, press the SDB/P.EQ equalizer
button, then press the surround mode button again for at
least 2 seconds.
3
After several seconds, “INITIALIZE” appears on the display
and the power turns on.
• The microprocessor is initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor is reset, all the buttons and the setup
settings are reset to the factory default values.
To Next Page
Loading...
Need help?
General
