Denon DN-C110 User Manual


Getting Started Connections
ENGLISH
Specications
Symptom Cause Countermeasure Page
Disc tray does not open. • The power is not on. • Turn on the power. 7
“NO DISC” is displayed even
though a disc is loaded.
• The disc is not properly loaded.
• Reload the disc.
2, 3
“00 Tr 00 : 00” is displayed even
though a disc is loaded.
• The loaded disc is not a CD. • Load a CD.
2
Playback does not start even when
the 1/3 button on the main unit
or the 1 button on the remote
control unit is pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the
disc.
3
No sound is produced or sound is
distorted.
• The output cables are not properly
connected to the amplier.
• The amplier’s function setting or
adjustments are not right.
• Check the connections.
• Check the amplier’s function and
controls and adjust as necessary.
6
–
No digital signals are output. • The connection cables are not properly
connected.
• Check the connections.
6
Specic section of the disc cannot
be played properly.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the
disc.
3
Programmed playback is not
possible.
• The tracks have not been programmed
properly.
• Programmed playback is not possible
with MP3 and WMA les.
• Program properly.
• Use a CD.
9
9
A CD-R or CD-RW disc cannot be
played.
• The disc has not been nalized.
• The recording conditions are bad or the
quality of the disc itself it poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
2
2
Set does not operate properly when
remote control unit is operated.
• The batteries are spent.
• The remote control unit is too far from
the set.
• Replace the batteries with new ones.
• Move the remote control unit closer to
the set.
3
3
“Not Support” is displayed when
playing les recorded in MP3 or
WMA format.
• You have selected a copyright-protected
WMA le or a le that cannot be played
normally.
• Use the
8 or 9 button to select a
different le.
10
Ifaproblemshouldarise,rstcheckthefollowing:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
DCD-510AE
Timer device
Using the Timer Play Function
1
Turn on the power of the connected components.
2
Switch the amplier’s function to input from the
connected main unit.
3
Load a disc in the player.
4
Set the audio timer for the desired times.

b Refer also to the owner’s manual of the audio timer.
5
Turn the timer “ON”.
The power of the components connected to the timer turns
off.
b When the set time is reached, the power of the different
components automatically turns on and playback starts from the
rst track.
Amplifier
AC outlet (Wall)
TroubleshootingPlayback

Denon DN-C110 Specifications

General

Brand	Denon
Model	DN-C110
Category	CD Player
Language	English