60
ENGLISH
Check again before assuming the player is malfunctioning
20
TROUBLESHOOTING
2 Are all the connections correct?
2 Are you following the instructions in the manual?
2 Are the amplifier and speakers operating properly?
If the DN-V200/DN-V300 does not seem to be functioning properly, check the table below. If this does not solve the problem, the DN-
V200/DN-V300 may be damaged. Turn off the power, unplug the power supply cord from the power outlet, and contact your store of
purchase or nearest sales office.
Symptom PageCheck
Power does not turn on.
10~14• Plug the power supply cord securely into the power outlet.
Playback does not start when PLAY
button is pressed.
Playback stops immediately.
—
7, 8
9
• Is there condensation on the disc or player? (Let stand for 1 or 2 hours.)
• Discs other than DVDs, video CDs and music CDs and Digital picture (JPEG)
cannot be played.
• Disc is dirty. Wipe off the dirt.
Picture does not appear.
10~14
10, 11
—
• Check the connections.
• Turn “P.SCAN” off when a TV is connected to the VIDEO OUT and S-VIDEO
connector.
• Set the TV’s input to “video”.
Sound is not produced or sound
quality is poor.
10~14
—
24, 25
• Check the connections.
• Properly set the input of the TV, stereo, etc.
• Check the “DIGITAL OUT” and “COMPRESSION” settings.
Menu playback is not possible.
30
33
• Check the “AUTO PLAY” setting.
• Menu playback is not possible with anything but video CDs with playback control.
Picture is disturbed during the
search operation.
—• Some disturbance is normal.
Buttons do not operate.
33
52
• Some operations are disabled for some discs.
• Check the “KEY LOCK” mode.
No subtitles are displayed.
—
27
• Subtitles are not displayed for DVDs not containing subtitles.
• Subtitles are turned off. Turn the subtitles setting on.
Audio (or subtitle) language does
not switch.
—
44, 45
• The audio (or subtitle) language does not switch for discs which do not include
multiple audio (or subtitle) languages.
• For some discs the audio (or subtitle) language cannot be switched when the
operation to switch it is performed, but can be switched on the menu screens.
Angle does not switch.
43• The angle cannot be switched for DVDs which do not contain multiple angles. In
some cases multiple angles are only recorded for specific scenes.
Playback does not start when the
title is selected.
30• Check the “RATING” setting.
The password for rating level has
been forgotten.
—• Use the procedure described below to set the initial settings back to the values
set when the unit was shipped from the factory. Input “1470” at 5 under step 3
on page 30.
The disc is not played with the
audio or subtitle language set as
the default setting.
26, 27• The disc does not play with the selected audio or subtitle language if that audio
or subtitle language is not included on that DVD.
Picture is not displayed in 4:3 (or
16:9).
22• Set the “TV ASPECT” default setting to the proper setting for the connected TV.
Menu screen messages for the
desired language do not display.
27• Check the default setting for the disc language’s menu language.
To Next Page
Loading...
Need help?
General
