ENGLISH
Operation
• Make sure that all the connections are proper by
referring to the rear panel.
• Check the polarity (positive and negative) of
connections, and the directivity of stereo separation
(right cord to right channel terminal, and left cord to left
channel terminal).
• Check the directivity of pin cord connection.
Preparation
2 Setting of each knob
•Turn the VOLUME control knob counterclockwise, to
minimum position.
• Set the BASS, TREBLE and BALANCE control knob, to center
position.
• Set the SOURCE DIRECT and P. DIRECT switches to “OFF (
£)”.
After checking the above items, turn on the power, the amplifier
is set in the ready mode in a few seconds.
2 Checking connections
POWER
PHONES
BASS
TREBLE
BALANCE
VOLUME
REC OUT SELECTOR
INPUT SELECTOR
P. DIRECT
SOURCE DIRECT
MUTING
TUNER
PRESET
DVD / AUXCD TUNER
TAPE-2 / MDTAPE-1 / CD-RPHONO
DISC
SKIP
FUNCTION
VOLUME
1
Select the input source to be played.
DVD / AUXCD TUNER
TAPE-2 / MDTAPE-1 / CD-RPHONO
(Main unit) (Remote control unit)
When “PHONO” is selected, press the CARTRIDGE
switch on the rear panel of the main unit to select “MC
(
¢)” or “MM (£)”.
2
Start playback on the selected component.
3
Turn the VOLUME, BASS, TREBLE and
BALANCE control knob to yield an appropriate
volume and sound quality.
For operating instructions, refer to the component’s
manual.
NOTE:
If P. DIRECT button is set to ON position,the P. DIRECT
terminals are selected, and the input indicator is dimmed
out.
Playing the input source
9
ENGLISH
To Next Page
Loading...
Need help?
General
Weight and Dimensions
