Denon RCD-M38 User Manual

ENGLISH
9
Getting Started Basic Connections
Basic Connections Advanced ConnectionsBasic Operations Advanced Operations TroubleshootingExplanation terms Specifi cations Index
Connecting recording components
CD recorder / MD recorder / tape deck
Audio cable (sold separately)
Stereo
pin-plug cable
R
L
R
L
(White)
(Red)
3- 3-
*/ 065
"6%*0
"6%*0
R
L
R
L
R
L
R
L
CD recorder /
MD recorder /
Tape deck
Connecting an antenna
AM/FM
• Connect the FM antenna or AM loop antenna included with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 14 “Tuning in Broadcast Stations”), use tape to fi x the
antenna in a position where noise is the lowest.
weq
AM loop antenna
(Supplied)
FM indoor antenna
(Supplied)
White
Black
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. Inquire at the retail store where you
purchased the unit for details.
Using the AM loop antenna
n To use suspended on
a wall
Suspend directly on the wall
without assembling.
Nail, tack, etc.
n To use standing alone
Use the procedure below to
assemble.
Assembling the AM loop antenna
1
Put the stand section
through the bottom of
the loop antenna from the
rear and bend it forward.
Loop
antenna
Stand
Square
hole
Projecting
part
2
Insert the projecting part
into the square hole in the
stand.
1.RCDM38E3ENG0041st.indd91.RCDM38E3ENG0041st.indd9 2010/05/1714:17:052010/05/1714:17:05

Denon RCD-M38 Specifications

General

Brand	Denon
Model	RCD-M38
Category	Car Receiver
Language	English