DeWalt D25951K User Manual

ENGLISH
20
Fig. E
5 2
Switching On and Off (Fig. A)
To turn the tool on, set the on/off switch
1
to position 1. To
turn the tool off, set the on/off switch
1
to position0.
Demolition, Chasing and Channelling
(Fig. A)

WARNING: Ensure that the cutting edge does not
show discoloration caused by too much pressure. This
may impair the hardness of theaccessory.
Various types of chisels are available as anoption.
1. Select the appropriate chisel. Clean and grease itsshank.
2. Insert the chisel and check whether it is properlylocked.
3. Fit and adjust the bail/loop style auxiliary handle
5
and
make sure it is firmlytightened.
4. Hold the tool with both the main handle and the bail/
loop style auxiliary handle and switch on. The tool now
runs in continuousoperation.
5. Always switch off the tool when work is finished and
beforeunplugging.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can causeinjury.
Your D
e
WALT power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regularcleaning.
Lubrication
Your power tool requires no additionallubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performingthis.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Accessories

WARNING: Since accessories, other than those
offered by
DeWALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
DeWALT
recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
servicecenter.
Repairs

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
DeWALT
factory service center
or a
DeWALT
authorized service center. Always use
identical replacementparts.
Protecting the Environment
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal householdwaste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to localprovisions.
SPECIFICATIONS
D25951-B3
Voltage 120V~
Power 1600 W
Frequency 50–60Hz
Impact Energy 24 J (17.7 ft/lbs)
Impact per Minute 1620 ipm
Vibration Measurement 8.8 m/s
2
Weight 29 lbs (13.3 kg)

DeWalt D25951K Specifications

General

Quantity per pack	10 pc(s)