English
55
FEATURES (FIG. 1, 4)
A. Chain lock J. Wheel
B. Spark deflector screw K. Guard
C. Spark deflector L. Wheel lock lever
D. Base M. Depth stop bolt
E. Fence N. Trigger switch
F. Vise O. Padlock hole
G. 8mm hex wrench P. Jam nut
H. Crank Q. Fence bolts
I. Vise lever
Power Supply
Be sure your power supply agrees with the nameplate marking.
120 volts, “60 Hz” means alternating current (normal 120 volt, 60 Hz
house current).
A voltage decrease of more than 10% will cause a loss of power and
overheating.
Cutting Capacity
The wide vise opening and high pivot point provide cutting capacity
for many large pieces. Use the cutting capacity chart to determine
total maximum size of cuts that can be made with a new wheel.
WARNING: CERTAIN LARGE, CIRCULAR OR IRREGULARLY
SHAPED OBJECTS MAY REQUIRE ADDITIONAL HOLDING
MEANS IF THEY CANNOT BE HELD SECURELY IN VISE.
WARNING: DO NOT CUT MAGNESIUM WITH THIS TOOL.
MAXIMUM CUTTING CAPACITY
NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position.
Workpiece Shape:
A x B
90° Cutting Angle A = 5" A = 4.75" 4.5" x 5" A = 5-3/8"
(130mm) (120mm) (115mm x 130mm) (137mm)
4" x 7-5/8"
(102mm x 194mm)
3" x 9"
(76mm x 229mm)
45° Cutting Angle A = 4.5" A = 4.25" 4.5" x 4.25" A = 4.5"
(115mm) (107mm) (115mm x 107mm) (115mm)
To Next Page
Loading...
Need help?
General
