DeWalt dcd708s2t-qw User Manual

English
3
No‑ load speed
1st gear
2nd gear
min‑ 1
min‑ 1
0–450
0–1650
0–450
0–1650
Beats per minute
1st gear
–
0–7650
2nd gear
–
0–
28050
Max. Torque (hard/soft) Nm 65/26 65/26
Chuck capacity
mm
1.5–
13
1.5–13
Maximum drilling capacity
Wood
Metal
Masonary
mm
mm
mm
30
13
–
30
13
13
Weight (without battery
pack)
kg
1.10
1.20
Noise values and vibration values (triax vector sum)
according to EN62841‑ 2‑ 1:
L
PA
(emission sound
pressure level)
dB(A)
73
88
L
WA
(sound power level)
dB(A)
84
99
K ( uncertainty for the
given sound level)
dB(A)
3
3
Drilling into metal
Vibration emission value
a
h,D
=
m/s
2
<2.5
3.0
Uncertainty K =
m/s
2
1.5
1.5
Drilling into concrete
Vibration emission value
a
h,ID
=
m/s
2
–
15.0
Uncertainty K =
m/s
2
–
2.9
Screwdriving
Vibration emission
value a
h
=
m/s
2
<2.5
<2.5
Uncertainty K =
m/s
2
1.5
1.5
The vibration and/or noise emission level given in this
information sheet has been measured in accordance
with a standardised test given in EN62841 and may be
used to compare one tool with another. It may
be used for a preliminary assessment of
exposure.
WARNING: The declared vibration and/or noise emission
level represents the main applications of the tool.
However if the tool is used for different applications, with
different accessories or poorly maintained, the vibration
and/or noise emission may differ. This may significantly
increase the exposure level over the total working period.
An estimation of the level of exposure to vibration
and/or noise should also take into account the
times when the tool is switched off or when it is
running but not actually doing the job. This may
significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the
operator from the effects of vibration and/or
noise such as: maintain the tool and the
accessories, keep the hands warm (relevant for
vibration), organisation of work patterns.
EC‑ Declaration of Conformity
Machinery Directive
Tool Connect™ Drill/Driver/Hammerdrille
DCD708, DCD709
DeWALT declares that these products described under
Technical Data are in compliance with:
2006/42/EC, EN60745‑ 1:2009+A11:2010,
EN60745‑ 2‑ 1:2010, EN60745‑ 2‑ 2:2010.
These products also comply with Directive 2014/30/EU
and 2011/65/EU. For more information, please contact
DeWALT at the following address or refer to the back of
the manual.
The undersigned is responsible for compilation of the
technical file and makes this declaration on behalf of
DeWALT.
Markus Rompel
Vice‑ President Engineering, PTE‑ Europe
DeWALT, Richard‑ Klinger‑ Straße 11,
D‑ 65510, Idstein, Germany
02.11.2018
WARNING: To reduce the risk of injury, read the
instruction manual.

DeWalt dcd708s2t-qw Specifications

General

Brand	DeWalt
Model	dcd708s2t-qw
Category	Drill
Language	English