8
ENGLISH
Date Code Position (Fig.B)
The date code, which also includes the year of manufacture, is
printed into thehousing.
Example:
2020 XX XX
Year of Manufacture
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual beforeuse.
Visible radiation. Do not stare intolight.
Package Contents
The package contains:
1 Cordless Screwdriver
1 Charger
1 Battery pack (G1 model)
2 Battery packs (G2 model)
1 Kitbag (G1 model)
1 Kitbox (G2 model)
• Check for damage to the tool, parts or accessories which may
have occurred duringtransport.
• Take the time to thoroughly read and understand this manual
prior tooperation.
Battery Type
The following SKU(s) operate on a 7.2 volt battery pack:
DCF680, DCF682
These battery packs may be used: DCB080. Refer to Technical
Data for moreinformation.
the latest regulations for packaging, labeling/marking and
documentationrequirements.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the time
the document was created. However, no warranty, expressed or
implied, is given. It is the buyer’s responsibility to ensure that its
activities comply with the applicableregulations.
Storage Recommendations
1. The best storage place is one that is cool and dry away
from direct sunlight and excess heat or cold. For optimum
battery performance and life, store battery packs at room
temperature when not inuse.
2. For long storage, it is recommended to store a fully charged
battery pack in a cool, dry place out of the charger for
optimalresults.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be recharged
beforeuse.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
L
Read instruction manual beforeuse.
p
See Technical Data for chargingtime.
q
Do not probe with conductiveobjects.
r
Do not charge damaged batterypacks.
s
Do not expose towater.
t
Have defective cords replacedimmediately
u
Charge only between 4˚C and 40˚C.
v
Only for indooruse.
x
Discard the battery pack with due care for
theenvironment.
y
Charge DeWALT battery packs only with designated
DeWALT chargers. Charging battery packs other than
the designated DeWALT batteries with a DeWALT
charger may make them burst or lead to other
dangeroussituations.
z
Do not incinerate the batterypack.
Description (Fig.A)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury couldresult.
1
Motion control activation trigger
2
Lock off switch
3
LED worklight
4
Battery fuel gauge
5
Battery release button
6
Battery pack
7
Quick release chuck
8
Chuck collar
9
Torque adjustment collar (DCF680 Only)
10
Release button (DCF680 Only)
Intended Use
These screwdrivers have been designed for professional
screwdrivingapplications.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
These screwdrivers are professional powertools.