DeWalt DCH263N User Manual

ENGLISH
10
Fig. E
13
14
Bit and Bit Holder

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage barehands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bitsonly.
SDS Chuck (Fig. F)

WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage barehands.
To insert bit, insert shank of bit about 3/4"(19 mm) into
chuck
15
. Push and rotate bit until it locks in place. The bit
will be securelyheld.
To release bit, pull the sleeve
16
back and remove thebit.
Fig F
15
16
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. G)
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
8
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
9
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.
Fig. G
8
9
Proper Hand Position (Fig. H)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the mounted
side handle
1
, with the other hand on the mainhandle
6
.
Fig. H
6
1
Operation Modes (Fig. I)

WARNING: Do not select the operating mode when
the tool isrunning.

CAUTION: Never use in Drilling or Hammerdrilling
mode with a chisel bit in the bit holder. Personal injury
and damage to the the tool mayresult.
Your tool is equipped with a mode selector dial 
4
to
selectthe mode appropriate to desiredoperation.

DeWalt DCH263N Specifications

General

Brand	DeWalt
Model	DCH263N
Category	Power Tool
Language	English