11
English
The cutting blades are made from high quality, hardened steel and with
normal usage, they will not require
FIG. 12
resharpening. However, if you
accidentally hit a wire fence (Fig. 12),
stones, glass, or other hard objects,
you may put a nick in the blade. There
is no need to remove this nick as long
as it does not interfere with the
movement of the blade. If it does
interfere, remove the battery and use a
fine toothed file or sharpening stone to
remove the nick. If you drop the
trimmer, carefully inspect it for damage.
If the blade is bent, housing cracked,
handles broken or if you see any other
condition that may affect the trimmer’s operation contact your local
DeWALT authorized service center
for repairs before putting it back into
use.
Fertilizers and other garden chemicals contain agents which greatly
accelerate the corrosion of metals. Do not store the unit on or adjacent
to fertilizers or chemicals.
With the battery removed, use only mild soap and a damp cloth to
clean the unit. Never let any liquid get inside the unit; never immerse
any part of the unit into a liquid. Prevent the blades from rusting by
applying a film of light machine oil after cleaning.
Accessories
WARNING: DO NOT use the hedge trimmer
with any type of accessory or attachment. Such usage might
be hazardous.
• READ INSTRUCTION MANUAL BEFORE USING. SAVE
INSTRUCTION MANUAL.
• Check the hedge for foreign objects such as wires or fences before
each use.
• KEEP HANDS ON HANDLES. DON’T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
CAUTION: BLADE MAY COAST AFTER TURN OFF.
MAINTENANCE
WARNING: Remove battery pack before servicing,
cleaning or removing material from the hedge trimmer.
Your D
eWALT tool has been designed to operate over a long period
of time with minimum maintenance.
Continuous satisfactory operation depends on proper tool care and
regular cleaning.
WARNING: Before performing any maintenance,
switch off tool and remove battery.
Lubrication (Fig.11)
1. After use, carefully clean the blades with a resin solvent.
2. After cleaning, apply a light film of lubrication to the exposed blade.
3. Insert the battery and turn the trimmer vertical with the blades
toward the ground and run the trimmer for a few seconds to fully
disperse the lubrication.
4. Keeping your hands away from the
FIG. 11
G
blade, slide the sheath (G) over the
blade until it snaps into place as
shown in Figure 11.
To Next Page
Loading...
Need help?
General
