ENGLISH
12
Only for indoor use.
Package Contents
1 Cordless jigsaw
1 Anti-scratch shoe cover
1 Dust port
2 Batteries
1 Charger
1 Instruction manual
NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 2, 6, 10, 11)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Battery release button
b. Battery pack
c. Trigger switch
d. Trigger lock button
e. Blade release lever
f. Bevel lever
g. Shoe
h. Orbital action lever
i. Dust blower control
j. Anti-scratch shoe cover
k. Clamp Mechanism
l. Guide Roller
m. Rear Tab
n. Anti-Splinter Insert
p. Main Handle
q. Top Handle
INTENDED USE
Your DCS332 and DCS331 jig saws are designed
for professional cutting of wood, steel, aluminium,
plastic and ceramic material at various work sites
(i.e., construction sites).
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty jigsaws are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your DeWALT charger is double insulated
in accordance with IEC 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
DeWALT service organisation.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm
2
; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENT
WARNING: To reduce the risk of
serious personal injury, depress the
trigger lock button and disconnect
battery pack before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
WARNING: Use only DeWALT battery
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fig. 4)
NOTE: For best results, make sure your battery
pack is fully charged. The light will shut off without
warning when the battery is fully discharged.
To Next Page
Loading...
Need help?
General
