DeWalt DCST925 User Manual

ENGLISH
8
Attaching the Auxiliary Handle (Fig. A, H)
1. Place the auxiliary handle
3
on top of the handle
base
19
so the upper trimmer pole
5
is betweenthem.
2. Hold the auxiliary handle in place and slide the handle
bolts
20
into the handle from the top, threading them
into the handlebase.
3. Tighten the handle bolts with the supplied hex
wrench
21
. Ensure the handle is securelyattached.
4. Repeat for the other side of the auxiliaryhandle.
Fig. H
3
5
19
20
21
Adjustment (Fig. H, I)

WARNING: To reduce the risk
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
oraccessories.

WARNING: Never remove the guard.
Damage or personal injury couldresult.

WARNING: NEVER OPERATE
APPLIANCE WITHOUT GUARD FIRMLY IN PLACE.
The guard must always be properly attached on the
appliance to protect theuser.
The auxiliary handle
3
is positioned to maximize balance.
However, if adjustment is necessary, loosen the four
bolts
20
with a hex wrench
21
and slide the auxiliary
handle
3
up or down the upper trimmer pole
5
.
Fig.I
5
3
20
OPERATION

WARNING:To reduce the risk
of serious personal injury, turn appliance
off and remove battery before making any
adjustments or removing/installing attachments
oraccessories.

WARNING: Always use proper eye
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating thisappliance.

WARNING:Remove the battery before
making any assembly, adjustments, or changing
accessories. Such preventive safety measures reduce
the risk of starting the TRIMMERaccidentally.

CAUTION: Before you begin trimming, only
use the appropriate type of cuttingline.

CAUTION: Inspect area to be trimmed and
remove any wire, cord, or string-like objects which
could become entangled in the rotating line or spool.
Be particularly careful to avoid any wire which might
be bent outwardly into the path of the appliance, such
as barbs at the base of a chain linkfence.
Installing and Removing the Battery Pack
(Fig. J, K)

WARNING: Make certain the lock-off
lever is not engaged to prevent switch actuation
before removing or installingbattery.
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack: Align the battery pack
11
with the rails inside the battery housing
10
and slide it
into the housing until the battery pack is firmly seated and
ensure that it does notdisengage.
To remove battery pack: Depress the release button
12
and firmly pull the battery pack out of the battery housing.
Insert it into the charger as described in the charger section
of thismanual.
Fig. J
11
10
Fig. K
12
Proper Hand Position (Fig. L)

WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper hand position
as shown.

DeWalt DCST925 Specifications

General

Brand	DeWalt
Model	DCST925
Category	Trimmer
Language	English