ENGLISH
6
Proper Hand Position (Fig. K)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position asshown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the main
handle
22
of the hammer and one hand on the side
handle
1
of the dust extractionsystem.
Fig. K
22
1
MAINTENANCE
Your
dust extraction system has been designed
to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper tool care and regularcleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from
power source before making any adjustments or
removing/installing attachments or accessories.
Be sure the trigger switch is in the OFF position. An
accidental start-up can causeinjury.
WARNING: Use only
replacementparts.
Replacing the Dust Brush (Fig.L)
WARNING: Wear approved eye protection and
approved dust mask when performing thisprocedure.
The dust brush will wear during use and will need to
bereplaced.
1. To remove the dust brush
18
, pry it away from the four
small tabs
24
holding it inplace.
2. Insert the new dust brush making sure it is securely held
by the four smalltabs.
Fig. L
18
24
24
Cleaning
WARNING: Blow dirt and dust out of all air vents
with clean, dry air at least once a week. To minimize
the risk of eye injury, always wear ANSI Z87.1
approved eye protection and dust mask when
performingthisprocedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Accessories
WARNING: Since accessories, other than those
offered by
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
recommended accessories should be used with
thisproduct.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact
Industrial
Tool Co., 701East Joppa Road, Towson, MD 21286, call
1-800-4-
(1-800-433-9258) or visit our website:
www.dewalt.com.
Repairs
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a
factory
service center or a
authorized service center.
Always use identical replacementparts.
To Next Page
Loading...
Need help?
General
