39
English
Motor Quick Release (Fig. 2)
1. Open the locking lever (I) on the base.
2. Grasp the motor unit with one hand, depressing both quick
release tabs (A).
3. With the other hand, grasp the base and pull motor from the
base.
FIG. 2
A
R
G
I
Bit Installation and Removal (Fig. 3)
TO INSTALL THE BIT
1. Remove the motor unit from the base unit, see Motor Quick
Release (if needed).
2. Clean and insert the round shank of the desired router bit into the
loosened collet as far as it will go and then pull it out about 1/16”
(1.6 mm).
3. Depress the spindle lock button (E) to hold the spindle shaft in
place while turning the collet nut (U) clockwise with the wrench
provided.
FIG. 3
E
U
TIGHTEN RESET TIGHTEN
NOTE: The unit is equipped with multiple spindle lock detents
allowing an optional “manual ratchet” method of tightening the bit.
To Tighten with the “Manual Ratchet” Method:
a. Without removing the wrench from the collet nut (U), release
pressure on the spindle lock button (E).
b. With the wrench still on the collet nut (U), reverse the tightening
direction to reset the wrench position.
c. Depress the spindle lock button (E) again and turn the wrench
clockwise.
d. Repeat the procedure until the collet nut (U) reaches desired
tightness.
To Next Page
Loading...
Need help?
General
