18
ENGLISH
upper side of the guard
1
and roll the guard up just enough to clear the
workpiece, as shown in FigureY. Avoid doing this as much as possible, but
if need be, the saw will operate properly and make the bigger cut. NEVER
TIE, TAPE, OR OTHERWISE HOLD THE GUARD OPEN WHEN OPERATING
THISSAW.
MAINTENANCE
Your DeWALT power tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regularcleaning.
WARNING: To reduce the risk of injury, turn unit off and
disconnect machine from power source before installing and
removing accessories, before adjusting or changing set-ups
or when making repairs. Be sure the trigger switch is in the OFF
position. An accidental start-up can causeinjury.
WARNING: To reduce the risk of serious personal injury, DO NOT
touch the sharp points on the blade with fingers or hands while
performing anymaintenance.
DO NOT use lubricants or cleaners (particularly spray or aerosol) in the
vicinity of the plastic guard. The polycarbonate material used in the guard is
subject to attack by certainchemicals.
Lubrication
Your power tool requires no additionallubrication.
Cleaning
Before use, carefully check the upper guard, lower guard and dust duct
to determine that they will operate properly. Ensure that chips, dust or
workpiece particles do not block of one of thefunctions.
In case of workpiece fragments jammed between the saw blade and
guards, disconnect the machine from the power supply and follow the
instructions given in Changing or Installing a New Saw Blade. Remove
the jammed parts and reassemble the sawblade.
Periodically clean all dust and wood chips from around AND UNDER the
base and the rotarytable.
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
thisprocedure.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth dampened only with water
and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into aliquid.
Worklight Cleaning
• Carefully clean sawdust and debris from worklight lens with a cotton
swab. Dust build-up can block the worklight and prevent it from
accurately indicating the line ofcut.
• DO NOT use solvents of any kind; they may damage thelens.
• With blade removed from saw, clean pitch and build-up fromblade.
Dust Duct Cleaning (Fig. A1)
With the saw unplugged and the saw head raised fully, low pressure air
or a large diameter dowel rod can be used to clear the dust out of the
dustductinlet
18
.
Optional Accessories (Fig.B–E)
WARNING: Since accessories, other than those offered by DeWALT,
have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only DeWALT
recommended accessories should be used with thisproduct.
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose 305 mm 32
Fine Crosscuts 305 mm 60
Woodworking Saw Blades (provide smooth, clean cuts)
Fine Crosscuts 305 mm 80
Non-ferrous Metals 305 mm 96
Consult your dealer for further information on the appropriateaccessories.
Protecting the Environment
Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal householdwaste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle
electrical products and batteries according to local provisions. Further
information is available at www.2helpU.com.
To Next Page
Loading...
Need help?
General
