DeWalt Flexvolt DCV585 User Manual

11
ENGLISH
Cleaning

WARNING: Using a damp cloth, clean dust
from air vents at least once a week. Wear proper
ANSIZ87.1 (CAN/CSA Z94.3) eye protection and
proper respiratory protection as required by OSHA or
other governmental/provincial institutions for the
application beingperformed.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Fig. I
22
23
21
5. Fit bag inside the tank ensuring it is not folded
orpinched.
6. Replace dust extractor head onto the tank and
latchsecurely.
Removing and Disposing the Bag
(Fig. A, G, J)
1. Press the three position switch
3
to the Off (O) position
and remove thebattery.
2. Unlatch the tank latches
4
and remove the dust
extractor head
6
from thetank
16
.
NOTE: It is normal for there to be a small amount of
dust in the tank even with the the bag properlyinstalled.
3. Rotate the bag until the two tabs align with the two
notches on the dust extractor and remove the bag.
4. Once the bag is removed it can be sealed fordisposal.
a. Peel the backing from the adhesive seal
24
.
b. Press the adhesive seal over the opening and
properly dispose of the bag. DO NOT reuse thebag.
Fig. J
24
Installing the Plastic Liner (Fig. A, I, K)
1. Press the three position switch
3
to the Off (O) position
and remove thebattery.
2. Unlatch the tank latches
4
and remove the dust
extractor head
6
from thetank
16
.
3. Attach the plastic liner
28
by passing the two tabs
21
on the bag opening past the two notches
22
on
thedust extractor as shown in Fig. I.
4. Rotate the bag a quarter turn until the square edge
23
is facingupward.
5. Fold the plastic liner over the top edge of the tank.
Fig. K
28
29
16
6. Replace dust extractor head onto the tank and
latchsecurely.
Removing and Disposing the Plastic
Liner (Fig. A, I, K)
1. Press the three position switch
3
to the Off (O) position
and remove thebattery.
2. Unlatch the tank latches
4
and remove the dust
extractor head
6
from thetank
16
.
NOTE: It is normal for there to be a small amount
of dust in the tank even with the the plastic liner
properlyinstalled.
3. Peel the backing from the adhesive tape
29
along the
top edge the plastic liner and seal the liner.
4. Rotate the plastic liner until the two tabs align with the
two notches on the dust extractor and remove the liner.
5. Peel the backing from the adhesive seal
24
. as shown
in Fig. J.
6. Press the adhesive seal over the opening and properly
dispose of the bag. DO NOT reuse thebag.

DeWalt Flexvolt DCV585 Specifications

General

Brand	DeWalt
Model	Flexvolt DCV585
Category	Vacuum Cleaner
Language	English