14
ENGLISH
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as often as dirt
is seen collecting in and around the air vents. Wear approved eye protection and
approved dust mask when performing thisprocedure.
Charger Cleaning Instructions
WARNING: Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non‑metallic brush. Do not use water or any cleaning solutions. Never let
any liquid get inside the tool; never immerse any part of the tool into aliquid.
C
Lubrication
Your power tool requires no additionallubrication.
MAINTENANCE
Your power tool has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper tool care and
regularcleaning.
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start‑up can causeinjury.
The charger and battery pack are notserviceable.
Wall Mounting
These chargers are designed to be wall mountable or to sit upright on a table or work
surface. If wall mounting, locate the charger within reach of an electrical outlet, and away
from a corner or other obstructions which may impede air flow. Use the back of the charger
as a template for the location of the mounting screws on the wall. Mount the charger
securely using drywall screws (purchased separately) at least 25.4mm long with a screw
head diameter of 7–9mm, screwed into wood to an optimal depth leaving approximately
5.5mm of the screw exposed. Align the slots on the back of the charger with the exposed
screws and fully engage them in theslots.
To Next Page
Loading...
Need help?
General
