This manual will guide you through the setup and use of all Reactor Series relay controllers. Following this manual in the sequence outlined is absolutely essential to proper understanding and use of
Reactor Series Controllers. Please review the entire manual BEFORE contacting NCD technical support. NCD technical support staff will direct your questions to this manual when applicable.
Page 5 Quick Start Guide: Connect ME
Connect ME Setup
Things you will need
A Computer running Windows XP or later versions
A Device with an Ethernet Connect ME module installed
An Ethernet cable
Computer-grade 12v DC regulated power supply
Before use
Networking may be an issue when configuring your Ethernet enabled device. We at National Control Devices are
not networking experts; we are IO and Relay Control experts. However, we do have some suggestions that might
make your setup process go more smoothly. To avoid most networking issues, make sure that the network on which
you are configuring your device has an Internet connection. This helps to ground the network and to stabilize the IP
assignment of the network. Most customer problems are based in this.
Another thing to be aware of, networks with password protection enabled or that require authentication can cause
connection problems with our devices. Your device will be unable to connect to your network because of the pass-
word verification process. It is suggested that you disable these settings and your firewall before you begin the set-
up of your device in order to avoid connection problems. During initial setup, you may log onto the module and save
your network password so that password protection and your firewall can be enabled following setup process.
Things to remember
Disable network password
Disable network firewall
To Next Page
Loading...
Need help?
General
