DigiTech BP355 User Manual

28
Drum Pattern List
Beats (8th beat) 1-5 jazz 1-4
Beats
(16th beat) 6-8 hiphp 1-4
rock 1-8 world 1-4
hRock 1-8 Met 4/4
metal 1-8 Met 3/4
blues 1-8 Met 5/8
groov 1-4 Met 7/8
cntry 1-4 met mtrnom
Aux Input
The Aux Input allows you to connect an MP3 or CD player to the BP355 and jam with your
favorite artists. The signal from your MP3 or CD player is output through the left, right, and
headphone outputs of the BP355. To use the Aux Input, connect the headphone output of your
MP3 or CD player to the Aux Input on the rear panel of the BP355 using an 1/8" stereo cable,
and press play on your MP3 or CD player. Use the playing device’s volume control and the
BP355’s Master Level knob to balance the levels.
Expression Pedal
The Expression Pedal on the BP355 can be linked to control the BP355’s Volume, Wah, Wham-
my™, YaYa™, or almost any of the BP355’s other parameters in real time with your foot. When
a parameter has been linked to the Expression Pedal, a minimum (heel) and maximum (toe)
value can also be specified. Apply extra pressure to the toe of the Expression Pedal to activate
the V-switch, and the Expression Pedal switches between the linked parameter and the Wah. The
procedure for linking a parameter to the Expression Pedal is as follows:
1. Press either Edit button until the Expression row has been selected (indicated by the LED
lighting on the Expression row).
2. Rotate Knob 1 until EXPPDL appears in the Display.
3. Rotate Knob 2 until the desired parameter to be linked appears in the Display. See page 32
for a complete list of parameters that can be linked to the Expression Pedal.
4. Rotate Knob 3 to select the minimum (heel) value the assigned parameter will reach with
the Expression Pedal in the toe up position.
5. Rotate Knob 4 to select the maximum (toe) value the assigned parameter will reach with
the Expression Pedal in the toe down position.
6. Store your Expression Pedal assignment to your preset. See page 12 for more information on
the storing procedure.
LFOs
The BP355 includes two assignable low frequency oscillators (LFO 1 and LFO 2) which
can be assigned to any of the same parameters available for assignment to the Expression
Pedal. A low frequency oscillator will automatically vary the value of the assigned parameter at
a steady rate. A minimum and maximum value each LFO will reach may be also be assigned.
For instance, if the Amp Gain was assigned to LFO 1, and the minimum value was set at 1 and
the maximum value was set at 99, the BP355 would automatically sweep the amount of

DigiTech BP355 Specifications

General

Brand	DigiTech
Model	BP355
Category	Recording Equipment
Language	English