Amp/Stompbox Modeling
Modeling is a technology that reproduces the tones popular modern and vintage amps and
distortion stompoxes. Values 1-9 increase the amp or stompbox gain and level.
All trademarks are the property of their respective companies and are in no way associated with DigiTech.
EQ
Equalization is used to shape the tonal response of your bass guitar signal. The EQ in the
BP50 is similar to the tone knobs on an amplifier. Values 1-4 cut the level of each band, 5 is
flat (no cut or boost), and values 6-9 boost the level of each band.
Bass (b1- b9 ) - The Value buttons adjust the amount of low end enhancement (Bass).
Mid (d1- d9)- The Value buttons adjust the amount of mid range enhancement.
Treble (t1- t9)- The Value buttons adjust the amount of high end enhancement (Treble).
Noise Gate
A Noise Gate is designed to eliminate noise while you are not playing. The AutoSwell
r1-r9 – based on an Ampeg SVT
a1-A9 – based on an Ashdown Bass
Magnifier
b1-b9 – based on a Fender Bassman
S1-S9 – based on a Sunn 200S
O1-O9 – based on an SWR Interstellar
Overdrive
t1-t9 – based on a Trace-Elliot Commando
o1-o9 – based on a Ampeg B15
H1-H9 – based on a Hiwatt Custom 50
y1-y9 – based on a Mesa/Boogie 400+
d1-d9 – based on a Fender Dual Showman
c1-c9 – based on an SWR Basic Black
F1-f9 – DigiFuzz Fuzz distortion
g1-g9 – based on a Guyatone OD-1
P1-P9 – based on a EH Big Muff Pi
L1-L9 – based on a Voodoo Labs
Sparkledrive
n1-n9 – based on a Boss DS-1
15
To Next Page
Need help?
General
