6
MAKING CONNECTIONS/APPLYING POWER
To connect the CabDryVR pedal to your system:
1. Turn down the input gain or volume of the device that you are connecting the CabDryVR's outputs to
(e.g., mixer, audio interface, DI box, etc. ).
2. Set the LEVEL knobs on the CabDryVR to 12 o'clock.
3. Make all audio connections to the CabDryVR as shown in 'Connection Diagrams' on page 7. It is
recommended to place any preamp or distortion effect before the CabDryVR inputs. Delay, modulation,
and stereo effects can be placed either before or after the CabDryVR pedal.
4. Connect the appropriate HARMAN power supply (not included) to the POWER input connector and
connect the other end to an available AC outlet.
5. Strum your guitar and gradually increase the input gain or volume of the mixer, audio interface, or amp
until the desired level is achieved. Ensure that no clipping is occurring in the CabDryVR or the device to
which you are connected. If clipping does occur, adjust levels accordingly to eliminate the clipping.
To Next Page
Loading...
Need help?
General
