Name: DigiTech CG Wizard
Brand: DigiTech
Rating: 5 (1 reviews)

To Next Page

To Previous Page

P a g e 4 | 11

Sensors spacing

Step 3:

Put the plane on the sensors and

proceed to the following

measurements

Step 3.a:

Draw a line between the rear ends of the main

sensors.

Measure the distance between the center of

this line and the rear end of the front sensor.

This distance is the sensors spacing.

Enter this distance into the application.

Questions and Answers:

Need help?

Do you have a question about the DigiTech CG Wizard and is the answer not in the manual?

DigiTech CG Wizard Specifications

General