3
1. Using the tip of a 1/4" guitar cable,
push one of the release pins in on
either side of the pedal, and remove
the pedal from the pedal chassis.
2. Remove the battery from the battery
compartment and disconnect the bat-
tery cable.
3. Connect a new battery to the battery
cable and put it back in the battery
compartment. Make sure the battery
cable does not interfere with the
spring or pedal switch arm.
4. Place one hole of the pedal over its
corresponding pin.
5. Push the opposite pin in and lower the
other side of the pedal into place over
the depressed pin. Release the pin.
When the pedal is properly fastened,
both release pins are flush with the
outer side of the pedal.
Battery Replacement Directions
To Next Page
Loading...
Need help?
General
