13
Stereo Operation
For stereo operation connect the guitar to the Input of the RP150. Connect one cable to the
RP150’s Left (Mono) output, and another cable to the RP150’s Right output. Connect one cable
to the input of one amplifier, channel of a mixer, or power amp. Connect the second cable to a
second amplifier, second channel of a mixer, or power amp. If connecting to a mixing console, set
the pan controls of the mixer channels hard left and right in order to retain stereo separation. If
connecting to a mixer, set the Amp/Mixer switch to Mixer. If connecting to two amplifiers, set
the Amp/Mixer switch to Amp.
Stereo Amp Setup
NOTE: When using a guitar amp,
it may be best to connect the
Output of the RP150 to the effect
return of the amplifier.
To Next Page
Loading...
Need help?
General
