Connecting a cable to the Input applies power to the RP55. Disconnecting your instrument
from the Input of the RP55 disconnects the battery power. Turn your amplifier(s) on and
adjust the volume(s) to a normal playing level. To prolong the battery life, disconnect your
instrument from the RP55’s Input when not in use.
The RP55 can also be powered with the optional power supply. Connect the plug of the
power supply to the power jack on the rear panel of the RP55. Connect the other end of
the power supply to an AC outlet. Turn your amplifier(s) on and adjust the volume(s) to a
normal playing level.
Presets are numbered locations of programmed sounds. Presets are recalled with the
Footswitches. The RP55 comes with 40 User Presets (Presets 1-40) and 40 Factory Presets
(Presets 41-80). The User Presets are locations where you may store presets you create.
The Factory Presets may not be saved over. From the factory, the 40 User Presets are
exact duplicates of the 40 Factory Presets. This lets you make your own presets without
the worry of losing any Factory Presets.
When you first apply power to the RP55, it powers up in Play mode. The far left LED lights,
indicating you’re in Play mode. In Play mode, use the Up and Down Footswitches to access
the presets.
8
To Next Page
Loading...
Need help?
General
