21
CLEANING HYGRO-THERMO SENSOR OF WIRELESS 5-IN-1 SENSOR
1. Remove the 2 screws at the bottom of the radiation shield.
2. Gently pull out the shield.
3. Carefully remove any dirt or insects on the sensor casing (do not
let the sensors inside get wet).
4. Clean the shield with water to remove any dirt or insects.
5. Install all the parts back when they are clean and fully dried.
SPECIFICATIONS
CONSOLE
Dimensions (W x H x D)
118 x 192.5 x 21mm (4.6 x 7.6 x 0.83in )without attach table
stand
Weight 370g (with batteries)
Main power DC 5V, 1A adaptor
Backup battery CR2032, 3V batteries (not included)
Operating temperature range
802.11 b/g/n
2.4GHz
Supported router security
type
WPA/WPA2, OPEN, WEP (WEP only support Hexadecimal
pressword)
Supported device for setup
UI
or PCs: Android smart phone, Android pad, iPhone, iPad or
Windows laptop
Recommended web browser
for setup UI
Web browsers that support HTML 5, such as the latest
version of Chrome, Safari, Edge, Firefox or Opera.
Support sensors
1 Wireless 5-in-1 weather outdoor sensor and up to 7
Wireless hygro-thermo indoor sensors
RF frequency
917Mhz (AU version)
RF transmission range 150m
Time display HH: MM
Hour format 12hr AM / PM or 24 hr
Date display DD / MM or MM / DD
Time synchronize method Through Internet time server to synchronize the UTC
Weekday languages EN / DE / FR / ES / IT / NL / RU
Time Zone +13 ~ -12 hour
DST ON / OFF
Note: The following details are listed as they are displayed or operate on the console.
Barometer unit hPa, inHg and mmHg
Measuring range 540 ~ 1100hPa (relative setting range 930 ~ 1050hPa)
To Next Page
Loading...
Need help?
General
