7
PROGRAMMING THE REMOTE TO CONTROL A SECOND
R
ECEIVER IN AUX MODE
If you have another DISH Network satellite receiver installed, you can
use this remote in AUX mode to control it along with your new
receiver. When you program the remote to control the other receiver,
the remote will send out IR signals to the receiver. You can program
the remote to control any other DISH Network satellite receiver, except
for following:
• TV2 on DISH 322, DISH Player-DVR models 522, 625, 942 and
ViP222 & ViP622 DVR
• DishPlayer 7100/7200
1 Turn on the other receiver and display the System Info screen
(see the receiver user’s guide for information on how to display
the screen).
Write down the address shown:
2 Press and hold the AUX button until all the other mode buttons
light up, and then let go of the button. The AUX button flashes.
3 Press the 3 button.
4 Use the NUMBER PAD to enter the address you wrote in
step 1.
5 Press POUND (#). The AUX button blinks three times.
6 Press RECORD to make sure the address and the remote matches
the address on the receiver.
5.3 Replacement.book Page 7 Friday, November 24, 2006 12:00 PM
To Next Page
Loading...
Need help?
General
