1820 - OPERATION 37
START-UP
1820 - OPERATION 37
START-UP
6. Start engine. If engine does not start within ten seconds,
release key, allow starter motor to cool, and try to start again.
If engine does not start after three tries, check machine.
Gasoline Engine:
Choke cold engine. Put key in ignition and turn to start posi-
tion. When engine starts, release key. Push choke in.
Diesel Engine:
Put key in ignition and turn to on position until glow plug indi-
cator goes out. Turn key to start position. When engine starts,
release key.
7. Engage pump control (orange) slowly.
8. Idle engine 3-5 minutes before moving. Engine will idle with
digging chain disengaged and speed/direction control in
neutral position.
9. Check controls for correct operation.
Improper control function could
cause death or serious injury. If control does not
work as described in instructions, stop machine
and have it repaired.
NOTICES:
• If interlock system does not work, contact Ditch Witch dealer.
Improper repair may allow machine to start or operate with a
control in wrong position.
• Do not wire or tape operator presence switch.
6. Start engine. If engine does not start within ten seconds,
release key, allow starter motor to cool, and try to start again.
If engine does not start after three tries, check machine.
Gasoline Engine:
Choke cold engine. Put key in ignition and turn to start posi-
tion. When engine starts, release key. Push choke in.
Diesel Engine:
Put key in ignition and turn to on position until glow plug indi-
cator goes out. Turn key to start position. When engine starts,
release key.
7. Engage pump control (orange) slowly.
8. Idle engine 3-5 minutes before moving. Engine will idle with
digging chain disengaged and speed/direction control in
neutral position.
9. Check controls for correct operation.
Improper control function could
cause death or serious injury. If control does not
work as described in instructions, stop machine
and have it repaired.
NOTICES:
• If interlock system does not work, contact Ditch Witch dealer.
Improper repair may allow machine to start or operate with a
control in wrong position.
• Do not wire or tape operator presence switch.
To Next Page
Loading...
Need help?
General
