EasyManuals Logo
Home>Dometic>Plumbing Product>2000 Series

Dometic 2000 Series User Manual

Dometic 2000 Series
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2
The model identication label is located on the toilet base
and will show the model number and serial number. Follow
instructions for removing toilet pedestal cover in “Pedestal
and Pedal Cover Installation” on page 3. If label is not
available, please refer to “Dimensional Specications” on
page 4 for toilet model identication.

1. Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, in the system. These
products damage the seals in toilets and dump valves.
2. Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc.) to be ushed through
the toilet.
3. Mechanical seal toilets, like Dometic units, are designed to only discharge directly into a holding
tank. Horizontal pipe runs as found in conventional residential or commercial plumbing systems cannot be
accommodated.
4. Toilet must be regularly cleaned and winterized according to “Cleaning” and “Winterizing and Storage”
procedures in this manual, or your warranty coverage may be voided.


To prepare the Dometic toilet for use, make sure water supply to the
toilet is connected. Turn on water supply and check system for leaks.
Flush toilet and check again for leaks.
Make sure the ushing instruction label (shown at right) is in plain
sight and easy for guests to read. 
       

To properly use the Dometic toilet, follow these simple instructions:
1. , lift or raise the ush pedal until
desired water level is reached. Generally, more water is
required only when ushing solids.
2. , push pedal all the way down until contents
leave toilet bowl. Water ow pressures vary at different loca-
tions, therefore holding the ush pedal down for 4-8 seconds may be required. We require a minimum ow at
the inlet of the toilet of 2 gpm (7.6 lpm) for proper ushing.
3. Allow ush pedal to snap back, which permits positive sealing around the ush ball.
4. A small amount of water should remain in bowl.


Important Information ............................................. 2
Toilet Model Identication ...................................... 2
How to Use ............................................................. 2
Installation .............................................................. 3
Pedestal and Pedal Cover Installation .................. 3
Cleaning ................................................................ 4
Winterizing and Storage ........................................ 4
Dimensional Specications..................................... 5
Deodorants and Special Tissue ............................. 5
Service Tip ............................................................. 5
Troubleshooting Guide ...................................... 6 - 7
Ordering Parts ........................................................ 8
Customer Service ................................................... 8
Warranty ................................................................. 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dometic 2000 Series and is the answer not in the manual?

Dometic 2000 Series Specifications

General IconGeneral
BrandDometic
Model2000 Series
CategoryPlumbing Product
LanguageEnglish

Related product manuals