4
® Bar Keepers Friend is a registered trademark of SerVaas Laboratories Inc.
® Clorox, Pine-Sol and Soft Scrub are registered trademarks of The Clorox Co.
® Comet is a registered trademark of Prestige Brands International.
® Drano is a registered trademark of S.C. Johnson & Son Inc.
® Pam is a registered trademark of ConAgra Foods.
® Sani-Flush is a registered trademark of Reckitt Benckiser Inc.
® Teon is a registered trademark of DuPont Co.
® WD-40 is a registered trademark of WD-40 Company.
For routine cleaning, use SeaLand
®
Toilet Bowl Cleaner (Fig. A). If this
SeaLand cleaner is not available in your area, use most any non-abrasive bathroom and
toilet bowl cleaner (Bar Keeper's Friend
®
spray cleaner, Clorox
®
toilet bowl cleaner, Sani-
Flush
®
toilet bowl cleaner, etc.). Please follow label instructions.
To avoid damaging the seal, DO NOT USE:
– abrasives (Comet
®
, Soft Scrub
®
cleansers, etc.)
– caustic chemicals (Drano
®
clog remover, etc.)
– lubricants and cleaners containing alcohols or petroleum distillates
(Pam
®
cooking spray, Pine-Sol
®
cleaner, WD-40
®
lubricant, etc.).
After a period of time, mineral deposits from hard water may build up on the ush ball or seal,
resulting in a slow water leak. To prevent this, periodically clean the ush ball and seal.
1. Remove minor debris from the ush ball and seal by slowly pressing and releasing the ush pedal several times. This will
loosen and rinse debris from the surfaces. Repeat several times for stubborn buildup.
2. If step 1 does not fully clean the ball and seal, clean with a soft bristle brush and SeaLand Toilet Bowl Cleaner. Turn off
water supply to toilet. Fully clean the top of the ush ball and under the seal where it contacts the ush ball.
3. After cleaning under seal, apply light downward pressure to top of seal while brushing around full perimeter of seal.
4. Turn on water supply. Press ush lever to open ush ball, and use brush and water to rinse away cleanser and deposits.
When a Dometic toilet is stored for long periods of time or may be exposed to temperatures below freezing, the toilet must be
winterized or stored according to one of the following procedures.
This toilet is not intended for use when exposed to temperatures below freezing.
Never use automotive-type antifreeze (ethylene glycol) in freshwater systems.
Use nontoxic antifreeze (propylene glycol) designated for potable water systems.
(See vehicle owner’s manual.)
(recommended method)
1. Pour antifreeze in potable water tank according to instructions from antifreeze manufacturer.
2. Flush toilet several times until antifreeze has owed completely through toilet. For toilets with hand sprayer, the hand
sprayer must be turned on to assure antifreeze is cycled through the sprayer.
1. Turn off water supply to toilet.
2. Remove water supply line from water valve (Fig. B).
3. Place a small container under water valve inlet to catch draining water.
4. Press ush pedal and allow water to completely drain from water valve and vacuum breaker.
5. Leave water line disconnected until threat of freezing temperature is past.
Never leave vehicle or premises unoccupied for extended periods of time with
municipal water supply or onboard water pump turned on when there is a possibility
of freezing temperature.
Toilet warranty does not cover freeze damaged water valve that may result from
improper winterization.
To Next Page
Loading...
Need help?
General
